ENA mod for Dummy 13

This is fanart of ENA (web series and game by Joel G) made from scratch using dummy joint system. Please read the description both for this mod and for dummy13 before printing! On first try it's not easy to print and not easy to assemble, some parts can break, some parts can be tighter/looser fit than needed depending on materials & printing conditions. Please note that for this mod you will also need: dummy 13 v1.0 (linked below) frame head, frame clavicle x2, frame knee/elbow x4, frame ankle x2, armor knee. This was experimental so printing is somewhat inconvenient, challenging in several places, and will require supports. Flip all limb parts horizontally – including shoulder and pant pieces – to lower break risk during assembly. The way I made shoulder and pant hip joints created a problem of different filaments printing too tight/too loose (dummy compensates this with frame pieces but I didn't have enough space for that here). So I included two versions of problem pieces, tighter fit and looser fit. You'll need to do test prints for them in filament you're planning to use, to see if joint is tight enough! Head, hair and hat are connected by hair strand piece. It's a bit tricky to put together, check fit of each piece before assembly. Heads are printed as one piece and painted. Theoretically it should be possible to print halves in two colors and glue them together but I wasn't sure how well it would hold frame insert so didn't try that. Long hair makes posing more difficult than I'd like but I haven't figured out better alternative. All alt pieces (heads/hairs) should be interchangeable. Megaphone is finished with elastic band bc I didn't want to make different handles for each different hand.