Ender 3 V2 Direct Drive Cable Guide -thinner, centered, lower zip ties

I created this remix because the original version was a bit larger than I needed, and I wanted to fit the cables in more snug. The original also broke when I went to attach the zip-ties, one bit snapped off. It was still usable, but I figured I'd adjust a few things. Made the cable channel thinner, so it fits just the hot-end wiring and the extruder cable. Moved the cable channel into the center of the plate Made the screw holes slightly larger, they now fit a M2.5 screw easily (you can see in the photo I used M2.5 nylon screws with nuts) Moved the zip-tie holes down a bit and adjusted the overall placement. I left 4 spots for two sets of zip-ties, I only felt two were really required for my setup. March 2023 Update: I've uploaded a new model with the correct hole spacing (31mm). You can see this version in the photos, printed in red. Thanks to the folks who let me know about the problem, and for providing the correct measurements for me :)