Ender 3 V2 Filament Guide + Cable Holder Revisited

Remix of the following two guides: https://www.thingiverse.com/thing:5193117 https://www.thingiverse.com/thing:7024143 I'm a beginner and no matter which orientation and settings I could not get this to print right. Totally my fault and I realize this completely. Frustrated, I loaded the stl into tinkercad, chopped off the cable holder arm and raised it slightly on the side of the guide. I then regrouped the pieces and chopped the very bottom portion off which resulted in a nice flat bottom for easier printing for the beginners who struggle like me. This is my first remix. Thanks to both creators! There are two stl files. I figured the first print would fail because of the overhang which I struggle with so I added a sloped reinforcement to make printing got a little smoother. This is only the main portion. You will get roller wheel, pin and clip from the original.