Ender 3 V3 SE; E3D Revo installation support files

A set of files to print before installing E3D Revo hotend on the Ender 3 V3 SE. Fan shroud - A bit shorter to accommodate the new nozzle length CR-Touch bracket - Shorter than stock by ~9 mm Bed spacer shims - Adds 3 mm to the bed height so the nozzle can touch the bed again Print using PETG or some other plastic that is more resistant to heat and stress than PLA. However PLA will work in a pinch. Print with your default settings. The fan shroud should be printed with snug paint-on supports, as such: 📷 Image redacted — claim this model to add your own media 📷 Image redacted — claim this model to add your own media It will make removing them much easier, especially if you use PETG. I will also recommend putting the shims on the bottom of the original spacer, it will help avoid softening of the plastic when the bed is hot. 📷 Image redacted — claim this model to add your own media