ESP32 Camera Holder and articulated arm for installation in an Ikea PLATSA

I am not sure what to call this model as it is 2 makes and a remix. But I wanted to show the model as a whole in one place, so, A nod to the following two models used to produce my end product as well as remix of the “ESP32 Cam Holder” only of the model shown below. https://www.printables.com/model/801363-esp32-camera-case https://www.thingiverse.com/thing:1897363 I was looking for an articulated arm for my ESP32 camera to monitor my printer in a home made printer cabinet using an Ikea Platsa cupboard. Using Michal Fanta ESP32 camera case as my start point, it took me a day to find the arms that appeared to suit my needs on Thingiverse , described as “tripod arms”. This only left the remixing of the “Cam Holder” to attach the two makes together and to the wall. A few spare M3 20mm nuts and bolts to connect them all together. I would suggest orientating all the bolts in the same direction to aid future tightening if needed. Thanks to all for your designs. 22/10/24: Added a new “Cam case bottom” with a larger Usb C port. The cable i was using was not quite wide enough and the new cable I purchased did not fit. It was also stiffer so i have rotated the camera so the cable now comes out of the top as this worked better.