Eufy Permanent Outdoor E120 Lights Bracket - With Screw Holes Parallel

DO A TEST PRINT BEFORE PRINTING A BUNCH This was made because some soffits have part of the rafters sticking out below them which makes it difficult to property align the lights. A solution is to buy long thin pieces of wood (8ftx1-3/8x5/8 for ~$1 each) and attach the lights to the wood. Then attach the wood to the soffit/rafters. This version will allow you to attach the lights to said pieces of wood or to place the lights in thin/small areas, or channels. Holes are 4mm wide and fit most standard wood screws such as #2 You may have issues with the thin walled corner lifting due to the thinness/height if you don't follow the suggested settings with PLA. IMPORTANT! Suggested Settings for PLA: Bed Temp: 65C minimum Brim: 2mm minimum outer brim needed w/ 0.1mm gap or less