European Jar Mouse Trap RMX

this remix was made to fit the Multi-Mouse Jar Trap by LoboCNC into a common european jar for pickles or olives. also added a remix of the ramp with a slot for a M8 nut to use as counterweight as an alternative to the use of coins or washers (which is also still possible). for a safer closing of the ramp you can glue a small magnet to the underside of the housing but the trap works without. measure the outer diameter of your glas without the thread, should be around 72.5mm. the inside should have at least 18-20cm depth (two times the height of the trap housing) for the mouse to be able to climb in completely and to turn around inside. everything else is still the same as the original model (see for a lot additional information about use and assembly), you will need two short pieces of 1.75 filament to install the ramp in place. printed mine in PETG using variable layerheight from 0.3 down with standard prusaslicer settings without support. if you want to be on the safe side before printing the trap you can use my 72.5mm Lid model to test the fit on your glas. check back on the trap frequently to prevent caught mouses to die in there. as always I highly appreciate every like, rating or make, same for remixing and sharing. donations will be forwarded to sea-watch.org