EVA 2.4 combined filament sensor and filament cutter

This toolhead filament cutter and sensor for EVA 2.4 with LGX lite Requires: 1 x 4mm ball bearing 2 x m3 nut (1 for cutting face 1 for spring tension) 1 x #17 craft blade 2 x M5 bolts + nylock nuts 1 x mouse button hot glue ideally to secure switch and connector 1 x JST XH 3-pin male header M3 tap Epoxy glue for blade Something to cut the blade down M3 Heat set inserts x 4 1 x Pen sprig bunch of m3 bolts assorted sizes m3 washer to go between lever and spring top and bottom lever should be rotated so they are flat on the bed. You do need support on. but you can block some of it out on the bottom section i printed in petg 0.2 layer height 0.4 line width if you need to edit design here is link to tinkercad so you can tweak as required https://www.tinkercad.com/things/39X3LkbiWIc-copy-of-eva-24-filament-cutter-and-filament-sensor?sharecode=UktHVt3ucBcFMHz1ZTN4Gwv7BM_8sXxIwQ2gXBfnKvI