Exhaust hose for GE (and probably other) portable AC systems

Designed this to span through my garage door so I could cut holes and have the AC vent outside. So this uses 3x10mm round magnets available for cheap on amazon. you just glue them in (mind your polarity). then you just install the outside vent on your door or wall, then add some glue and install the bug shield, then add some glue and install the inside sleeve. once you have that, you just snap the adapter ring onto your house, and then you just snap it together using the magnets to hold it in place. P.s. I hate supports, so most the stuff i design is designed not to have them. You shouldn't need to use supports on any of them unless your printer can't span the cavity for the magnets well enough, my elegoo carbon had no issue.