Extended baseplate for Parkside PMFAP router

I needed more stability for my Parkside router, so I designed an extended baseplate quickly. It gets the job done, you can mount it in 4 different orientations with the factory screws that are installed on the factory baseplate (You have to remove the factory baseplate to install this one). It takes a bit of reach out from the toolhead, because I wanted it to be thick enough so that it would not bend. I printed it with Qidi CF-PLA, holding up perfectly, though it seems to be a tad bit draggy. You may want to use a more "slick" material, or just seal the bottom of it, if you want it to be slicker.