Extruder Cable Guide for Ender 3 S1 and CR10 Smart Pro by MAXPROBE - Strain relief for Creality Sprite extruder ribbon cable - Cable holder cable mount suits Creality CR10 Smart Pro Ender 3 S1 Pro

Extruder ribbon cable strain relief cable guide Developed by MAXPROBE for the Creality CR10 Smart Pro with Sprite Pro extruder, allows full x-axis gantry movement without hitting the frame. Fitting a cable guide to your printer allows the ribbon cable to flex gently over its length rather than all in one place which prevents the cable from getting damaged over time - a known issue with the sprite extruder ribbon cables. Features Uses original components and fasteners Fully reversible Easy to install Suits Creality CR-10 Smart Pro Creality Ender 3 S1 Creality Ender 3 S1 Pro Sick of auto bed leveling issues? So are we, that is why we developed the MAXPROBE backplate - the solution to auto bed levelling issues on Creality printers with the Sprite Pro Extruder such as the CR10 Smart Pro and Ender 3 S1 Pro. It is easy to install, uses all standard components and does not require cutting any wires. Download the MAXPROBE backplate here 📷 Image redacted — claim this model to add your own media Choosing the right STL Two different STLs are provided: Choose normal if you have long fasteners (9mm thick original mount) Choose recessed if you have short fasteners (7.5mm thick original mount) Print instructions Material: PLA or PETG Layer height: 0.2 Walls: 1.6 thick (0.4 line width) , 1.5 thick (0.5 line width) Top/bottom thickness: 1.6 Infill: 35% grid Supports: Required, recommend tree supports at the back only like below: 📷 Image redacted — claim this model to add your own media Installation instructions Fit the MAXPROBE cable guide to your extruder Install the ribbon cable into the plug on the extruder Insert half the cable into the rear of the guide the gently bend the cable over to insert the other half Move the cable over as far as possible in the clamp on the gantry to give the cable as much room as possible