FaceShield RC1 - A4 punched pocket version

This is a derivative of the Prusa face shield , and is a variant of their Release Candidate 1 ('RC1'), adapted to use an A4 punched pocket , which you might find at your local supermarket, and it is very possible that you have hundreds lying around in the office already. You can also use a perforator on the 'A6' setting to punch holes from both sides. You're able to easily attach/detach a perforated pocket, allowing you to replace these away after a single use. The 3D printed part can be soaked with soapy water to clean it. It is reusable. You can attach a 'buttoned elastic band' as mentioned in the original Prusa blog article . A thick rubber band with holes in it also works well. If you have other ropes or threads, you can use these as well; I have included to small holes that you could thread these through if desired.