Flipper Zero Case

**9/26/22** Updated model that uses 4mm screws with larger hinges and a small insert for an SD card in the top shell. Enjoy! Might revise the hinges since they seem like a weak point. I needed to drill the holes out a bit but other than that everything was an easy fit. To get the colored text, I printed using .2mm layer height and printed the text first. When it finished, I immediately ran the top lid right on the same spot without removing the text. The heights should line up just right to form a clean first layer but your tolerances may require some fiddling with settings. The video I followed for that trick is below.