Frankford X-10 Bullet Collater Plates

Made these plates to use with the FA Pew Pew collator. These add rifle round capabilities to the collator. I did buy the rifle version but I did not want to keep swapping/mounting the collators based on the rounds being reloaded. These just allow you to just use the one (pistol version) unit. Note that the feeder tube is smaller on the rifle collator (if you also purchased the FA rifle bullet feeders). I plan to make a adapter for those in the near future There are two 223/5.56 plates, one fits most, one for 55 gn. One for 224 Valkyrie (long 75+ gn 224). 38/357, 9mm, 45ACP, two for 308/6.5, one fits most and one for Varmit type that are very short. The 308 works with the 6.5 bullets (such as 6.5 Creedmoor) and 300 Blackout This has been tested with the following sizes: 55gn .224 Spitzer Poly Tip (Nosler) 55gn .224 FMJ (Hornady) 62gn .224 BT Poly Tip (Nosler) 73gn .224 ELD Match (Hornady) 77gn .224 HPBT (Nosler) 62gn .224 BT (Berger) 80.5gn .224 (Berger) 88gn .224 ELD BT Poly Tip (Hornady) 130gn Varmint HP Flat Base (Speer) 110gn Varmageddon Poly Tip (Nosler) 125gn FMJ (Hornady) 110gn Tac-Tx Blackout FB (Barnes) 120gn Tac-Tx Blackout FB (Barnes) 150gn FMJ/BT (Hornady) 150gn Ballistic Tip BT (Nosler) 168gn HPBT (Sierra) 220gn Blackout (Speer) 3D printing settings Printed with PETG but any decent material will do. Printed with a .4 nozzel on a Bambu Labs A1 with basic support. With the AMS I printed the labels white to see them better. Also added a Storage holder that you can stack the unused plates on to keep them tidy when not in use