Gemmy YEF-80 nozzle to cheap fan hole connector.

This 3d print requires supports. How to use this part: 3d print with supports and extra infill if desired. Run your YEF-80s lights through the hole in the center connector so that they come out the hole through the side that says "Inside". Snap the side opposite to the word "Inside" onto your Gemmy YEF-80's nozzle. Glue isn't necessary to keep the part attached to the blower nozzle but can be used for extra support. Use a zip tie and zip tie the connector into the hole of the inflatable where a cheap blower was or in any other desired location using the grooves around the edge of the parts. If the supports came off messy, sanding the grooves to make them cleaner and deeper can help with holding the zip ties on. I used this part to replace the cheap fan on my Morbid Enterprises ECTO-1 with a YEF-80 blower. It holds on well considering the YEF was somewhat overkill I printed mine with Grey PLA. When I first used this part I printed it in multiple pieces and glued them together with super glue and E-6000 glue to avoid supports. I hope to upload that version eventually once I make it more "User friendly" Feel free to make changes to this part and upload it. All I ask for is attribution.