[Gen2 Drawer] Male-to-Female Rail Joiners/Connectors

Had some stabilizers already installed preventing the installation of corner rails/drawers, and honestly I'm just lazy to remove them. Still wanted to make use of the full space width for the drawers, so I made this adapter to extend the reach of bins below the stabilizers without the need for rails (as a temporary solution at least). Originally it was only meant for overhanging lighter bins, but found a couple of other traits that might make it useful for others. Installation Tips MTF connector pieces can be slide into either the top or bottom of the existing bins/rails. Do not hang heavy bins directly on the rails right away. Causes play/sagging on the adapter. 📷 Image redacted — claim this model to add your own media Instead, ensure the taller/heavier bins are centered or is supported by a direct rail above. (This will allow lighter bins to lean on the center bins as support). 📷 Image redacted — claim this model to add your own media Two variants of W3 models are provided to accommodate different bed sheet sizes. [XL] Full-Sized: Can print as a single on Prusa Core L/XL or similar sizes. [CORE] Split into two smaller pieces that can fit on Prusa Core ONE+ (~250×220mm). Fit 2 pieces together as shown below when sliding it into the bins. 📷 Image redacted — claim this model to add your own media