Generic WebCam Mount for Sovol SV-06

NOTE: Update available: Updated Generic Camera Arm for SV06 & SV06+ As this is my model, I'd like to point to you an improved version. This is a Remix allows for the Webcam to be attached by use of a 1/4" x 3/4" Stainless Steel Hex Bolt. Rather than disassembling the Webcams to attach it to the mount. Attach the mount using an M3x25mm screw. After remodeling the First Revision, the Camera mount did work but it appear to vibrate with the load of the entire Webcam Attached while printing. This did not effect the Time laps Snap shot but it was seen in the live stream. So I went back to the original maker's file and extracted just the Motor Mount part of the file and proceed to redesign a stiffer, longer and lower mount to see if I could get a better views of the print nozzle while printing. The Third Rev did make a more stable mount and gives a good views of the print head and model, but was not low enough the actual see the nozzle. The Fourth Rev was low enough to actually see the nozzle and stiff enough not stop the vibration. So i wen with this version for my printer. I have add a shorter version Rev 5 to get a closer view of the nozzle. I then made one final modification to Rev 3 and 4 to allow for the addition of Zip Ties to hold the cable in place. Modeled in Autodesk Tinkercad Printed in Blue PLA layer height .2mm 20 % infill. (for stiffness)