GEPRC Pulsar LR 10 3D Printed Parts

This is my first upload there may be slight errors but the things fit just fine and you'll be very happy I'm sure. I searched high and low for the GepRC Pular LR 10 arm bumper and only found one on maker world but couldn't download it. Got inspired to do it myself so here you go. I printed mine in TPU. I even replicated the zip-tie (tie-wrap) I saw on the maker world version. I hope this helps others. I've worked really hard on the VTX holder. I designed it to hold the Caddx avatar GT VTX unit in the front. It simply wedges between the fronts of the two front arms and is very snug. You just need to line it up right and press it in and it sits tightly there with the front part being held by the center stand off. The Center Piece is my version of the center key which holds the arms in place. I've done this so that I can run my Rx antenna wire through it and to also enable a bottom mounted battery-strap to pass below the center key for a bottom mount battery option which I will use. Special Note! : In order to make use of this with your Rx antenna as I've shown, you'd actually need to sand down part of you arms so as to allow the Rx antenna wire to pass through the channel I've created in my print file. Otherwise you can just use it for a bottom mounted battery only and run your Rx wire above the arm mount plate rather than through it as I've done. The landing pad is a remix of one I found on Thingiverse (GEPRC Pulsar 10 - TPU Master Pack - 6810055) credit where it is due link to the original here; https://www.thingiverse.com/thing:6810055 I've modified mine to be taller and with wider holes to support the PETG washers I've made. I use them since TPU warps when you screw it down tight. They range from 1mm to 3mm. link to the motor vibration dampener collection is here https://www.thingiverse.com/thing:2038918 ( I did not include a file but you have the link) I remixed the camera mount to make it compatible with my Avatar GT Cam. The original only supported DJI. Now you can use both. Left to complete: 2.4 Ghz antenna holders ( not too sure where I'm going to mount them as yet)