Giant underdesk cabinet with 2 drawers (with optional Gridfinity insert)

You need drawers under your desk and have a lot of stuff to put in there? Well, then this might be what you were looking for! This is a big drawer cabinet which can be glued or screwed underneath your desk (if there is enough space underneath). The cabinet has lots of space (for an underdesk drawer). Note: Even though the model does use holes to reduce filament, it is still using a lot of filament. The frame alone is close to 1KG spool. I printed the outer shell and the rails in PETG and the drawers in PLA. Note: I do have two different upper drawers, one full and one with a separate divider to allow a tabletop rail to have space inside the drawer element. There are two main boxes, one uses a bit less filament, but it is tricky to print and prints much longer. I did print the drawer multiple times. The second incarnation had a stuck filament at the printer towards the end and I created a special front to make use of it anyways (see picture). However - as it is highly unlikely that you would get into the same situation, I did not upload that model. Extensions I created many months later to the underdesk cabinet and / or the lower drawer: If you encounter that the drawer element might shift when pulling a drawer, you can add the drawer lock . Furthermore I created a Gridfinity inset which can be downloaded from here. And there is also a drawer in drawer for screwdrivers which can be downloaded from here .