Giyo GP-41 air pump Presta/Schrader Converter

Lost this piece of my pump, aparently they don't sell it as a spare part, so I made one. It is a 2 part design to avoid supports. I printed this in PLA at the standard quality preset on Cura. The parts turned out good, but I had to clean out the holes in the top part using my Dremel and a diamond burr that fits. In the small tube, I stuck it on a drill bit in my cordless drill and used a file to clean up the outside so it would fit into the top. Glued them together with just a drop of CA glue, and it's done. PS: The larger diameter on the part is 11.5 mm so it's probably gonna fit in other pumps within the same size.