Glue-on washer fix for Cisco's Claw 2 print in place toy

The rim on the pins kept breaking off, because my kids really enjoyed rough playing with this toy. I didn't want to throw out the already printed ones, so I printed an additional assymetric washer to fix it. I used E6000 glue, but you can use superglue as well to glue it in place. The part is assymetrical, the smaller side goes on the claw's pin, bigger side faces up The hole in the middle is intentional, so any excess glue can come out through it, instead of flowing sideways and fusing the toy. Printed at 0.16 layer height.