GPU support bracket

Unlike most items in this category, this one is not adjustable at all, so if it works for you it works, and if doesn't you are more than welcome to stretch/shrink it or otherwise remix! I built my PC in an ASUS Prime AP201: https://www.asus.com/ca-en/motherboards-components/cases/prime/asus-prime-ap201-microatx-case/ And the GPU being supported is an RX 9070: https://www.asus.com/ca-en/motherboards-components/graphics-cards/prime/prime-rx9070xt-o16g/ The case has a bunch of holes in the bottom, I guess for mounting fans or disk drives, but I repurposed two of them to screw in my bracket; I used a part of button-head M5 screws; anything 4-8mm in length would work great. My print was in polycarbonate with the default settings, though I expect you could print this in anything, just watch for slip over time if you use PLA, especially if your case is prone to getting warm. Print it with the longer of the two front faces against your print bed, and no support is needed.