Gridfinity 1x7 Printing Plate Holder - Middle Plate Holder

I made a middle plate holder for the design by @maxelman . This will allow whoever prints this to have increased contact area with the print beds, more magnets resisting them falling over, etc. You could theoretically print 5 of these to span the gap and make a near-continuous slot! I printed in basic PLA with 15% gyroid infill, no supports, no raft/brim, 2 walls, 0.4mm nozzle, 0.2mm layer height. Dimensions: 42mm W x 42mm D x 50mm H Filament: 25.8g (estimate in Bambu Slicer)