Gridfinity Screwable Magnetic Base Plates

Remix on Plastic Flow's baseplate design. The original design was my favorite base plate model except for one thing: you must glue the magnets in! It's also near impossible to remove them once they are glued in without damaging the base plate. These now have press fit magnet holes, which are also removable if you push them out from the underside! Everything else on the original model was great, so these were the only changes made. SETTINGS Nothing special, whatever your favorite Gridfinity settings are. No supports needed, brim if you had bed adhesion issues. PARTS m3 x 10 Screws m3 nuts 6 x 2mm Magnets NOTES Thanks to Plastic Flow for the original model! You can find spacers for these baseplates on their page! Check out my 3D printing YouTube channel- Hot Plastic!