H2T - Case for Heltec T114 with GPS running Meshtastic

A GPS enabled Meshtastic® case for the Heltec T114 board with GPS module. Install the buttons, board, GPS module, SMA Pigtail and snap the 2 halves of the case together. Secure with a M3 screw for a rock solid enclosure. 📷 Image redacted — claim this model to add your own media License and Fair Use This design is for personal use only. Any commercial use including copying, selling, trading or promotional use is not permitted unless an agreement is made with the owner, MUZI WORKS LLC. Contact us for business inquiries. Creative Commons (4.0 International License) Attribution—Noncommercial—Share Alike Note: The Heltec T114 is brand new and the firmware is not yet in the Meshtastic web flasher. You can find the firmware in the official Github repository here: https://github.com/meshtastic/firmware/releases Print suggestions: Face down, no support is required Optimized for 0.12mm layer height for a clean floating hole Build tips: The clear plastic frame for the display must be removed, re-use the screws (do not over tighten!) Clean the print at the screen opening to prevent excess pressure to the display Clips are pretty strong (and durable) this time around. Apply moderate pressure but make sure you're not pinching any cables. Once everything is working well screw it shut with a M3 screw. Take your time and enjoy the process! Fits: Battery up to 8mm x 31mm x 60mm U.FL to SMA Pigtail 10cm long Your choice of SMA antenna up to 12.7mm in diameter at the base Recommended component kit: https://muzi.works/products/heltec-t114-kit Dimensions: 50.9mm x 72.7mm x 19.7mm [2.00in x 2.86in x 0.78in] 27g [0.95oz] Purchase a pre-built device or case only from our web store: https://muzi.works Meshtastic® is a registered trademark of Meshtastic LLC. Meshtastic software components are released under various licenses, see GitHub for details. No warranty is provided - use at your own risk.