Hinged FL D3vil Wears Prada

The hinge for my K1C door broke, so I've been using some 3D printed hinges in their place. Unfortunately there is not enough room for the bottom most hinge to be used alongside the D3vil Wears Prada replacement feet. I found this hinge remix from @ThiagoBini_713535 , but it required drilling a new hole in the side panel and I wasn't about to do that, so I ended up just merging that hinge into the FL Foot and this is the result. It's not the cleanest model currently, I'll probably clean it up at some point, but it's fully functional as it is. I used supports since half the hinge was floating in the air. You can try without it, but YMMV You will need to print a nut trap for the hinge, I'm not uploading one because there are already plenty of sources for it. I used this one from @Mordiev