Hotas warthog mount

Assembly Notes To assemble this mount, you will need a few additional parts: 2 large extension springs (stretching springs, not compression springs) 20 × M5 screws, ideally around 80 mm long (slightly shorter can also work) M5 washers to properly secure the screws The support arm is designed to fit into a desk with a 27.5 mm thickness. If your desk has a different thickness, you may need to adjust the scale of the part or slightly modify the model to ensure a proper fit. The design can easily be adapted depending on the thickness of your desk. Printing Orientation (Important) The support arm shown in the photos must be printed on its side, exactly as shown in the preview. This orientation is important to ensure the best mechanical strength of the part. Printing it in another orientation may place the layer lines in a weaker direction, which could cause the part to break under load. By printing the part on its side, the layers are aligned in a way that greatly improves resistance to stress and bending, making the mount much stronger and more reliable during use.