HP Otto Benchy Remix! V2 (FIXED)

This is a benchy remix of the Otto robot. Inspiration was took from this model: https://www.printables.com/model/1631697-low-rider-otto-hp-module , although I didn't remix the model. Material: PLA or similar Layer height: 0.2mm or less Supports: Tree supports, on build plate only Perimeters: minimum 3 Infill: 15% or higher Hardware needed: 4 servos for the wheels 4× M2.0 screws for the benchy arms. Otto robot assembled 3d printed parts Basic Assembly instructions: Slide the "otto benchy arms" onto the assembled robot Put the servos onto the designated holes Tighten it onto the main robot body using the screws. Remove the original top-lights & face plate Put the benchy version of top lights and face plates on Hardware for V2 2 servos for the wheels 2× M2.0 screws for the benchy arms. Otto robot assembled 3d printed parts Superglue Basic assembly instruction for V2: Add the "Otto ball extender" to extend the ball. You might need glue Slide the "otto benchy arms" onto the assembled robot Put the servos onto the designated holes Remove the original face plate Put the benchy version face plates on Glue the pipe as shown in cover picture Pls print & download