HSW 4x Tweezer Holder

Holder for 4 tweezers. Remixed from @Kajry 6-tweezers holder. Added version with 2 pins for greater stability and also a version with rotated pin(s) to fin into the Honeycomb Storage Walls mounted 90° rotated compared to the original design. Dimensions of the slots are 12x5mm each; and 48mm deep. Note: version with 2 pins contain my own pins which were designed for a very tight fit . Either use hammer to hammer then into the inserts, or slightly downscale the model. Printing Print upright. No support needed for single-pin versions ; for 2-pins versions, I recommend organic supports. I printed mine in PETG with 5% infill (you can probably even have no infill), 6mm nozzle, and 4mm layer height; however, any combination of material, nozzle diameter, and layer height should work - this is a very simple model, so there are basically no restrictions.