Hue LED Light Strip Holder

I created this print because the glue used to stick the light strip to the bottom of the shelf was not good enough to keep the item suspended and after a while (days or at most a week) the light strip would fall down. I used some small screws (that had a diameter of around 3 mm) to fasten the holder to the bottom of the shelf. If you get a warning in PrusaSlicer that “The dimensions of the object seem to be defined in meters” don't worry, it's size will still work just fine. This may work for other light strips but I only had the Hue Light Strips to work with. Print instructions: I recommend printing the item on its side. No supports are needed (if printing on the side). 15% infill. Print Settings 0.20mm QUALITY works fine. Copy and paste the one item for how many as you need.