HW100 accessory tray inlay

Inlay tray for a JSB Exact box for HW100 accessories - Print flat base down, supports not needed Designed and tested by myself for printing with PLA/Nylon - I have tested this print on a Bambu H2S and P1S with 0.4mm nozzle at 0.16 layer height in PLA with default settings as well as Markforged Onyx using Onyx material at 0.125 layer height - Should work fine with majority of layer heights and infill; % Both printed fine and the fit was just as good as each other, obviously if you use a Bambu and AMS then you can change the text to stand out against the case © 2026. This work is openly licensed via CC BY-NC 4.0 https://creativecommons.org/licenses/by-nc/4.0/