IGRARING-V3 Cable Organizer with hook (flexible, PLA)

This variation of the previous model includes a flat hook, the hook was designed to give instead of breaking. Once a maximum load is applied it will bend and slip; this maximum load depends on the material properties (if PLA is used, it will also depend on brand and type of PLA). It will however hold most cable bundles, otherwise just try to print it bigger! My settings: 0.40mm nozzle, 0.20mm layer height. 15-17 minute print (1.6 grams) A sidenote: Depending on the printer itself the hook may snap/close tighter than normal, if this is the case you can always use the hole from the male portion to your advantage, just slide a small enough Allen key and use it to pry it open. Work smart!