iMac G3 IO panel/IO shield with VGA port and tabs

Printing Note I have added some tabs to stop this from falling into the mac, but they stick off of the big flat part, so this version must be printed with supports. When printing, your slicing software may try to place it on its side, but I found it better to print in the same orientation as you would with the the original design, but with a couple of milimeters of supports. This should be the orientation of the object in the STL file. There is also a picture showing the sliced version for reference, the yellow part is the support. About Remix of Diepzeevogel's replacement IO shield/IO panel for iMac G3, with just a VGA port. The other file is a bracket to zip tie or otherwise secure your VGA receptacle to, then superglue onto the main shield. I made this while following the iMac G3 monitor conversion instructions here: https://github.com/qbancoffee/imac_g3_ivad_board_init