Jet Engine Pipes

Each pipe is cut in half (A & B) so that they can lay flat on the printer bed, and then they are glued together, then to the engine itself. For the setup on my engine in the pictures, you'll need to print the following: Box - x1 Box to Fuel A & B - x1 each Box out A & B - x2 each Fuel Injectors A & B - 1x each Rear 1 A & B - 1x each Rear 2 A & B - 1x each Rear 3 A & B - 1x each Rear to Fuel A & B - 2x each Clamp - 3x each Check the posted design photo for a reference of what each part is. I hope you enjoy!