John's Overhang-xiety Eliminator — Support Calibration Model

Supports. The necessary evil of 3D printing — and the setting nobody tests until something goes wrong on a print they actually cared about. Spoiler: this won't actually eliminate the anxiety. But it'll replace the guesswork with real data. The Overhang-xiety Eliminator gives you a standardized, repeatable geometry to test your support settings against. Multiple overhang angles, bridge spans, and support-dependent surfaces — all in one quick print. Works with any slicer, any printer. Run it. Tweak a setting. Run it again. Know exactly what changed and why — before it matters. -- WHAT YOU GET -- Multiple overhang angles and bridge spans in one model Slicer agnostic — Cura, PrusaSlicer, Orca, whatever you run Fast enough to iterate multiple times in one session Repeatable geometry so every test is an honest comparison If you dial in a clean result, post your Make and drop your settings in the comments. Your dialed profile is worth more to this community than a like. (Printing it upside-down is cheating. I know you thought about it.)