JST Pliers with M4 screw

My apologies… I forgot to mention that the modifications I made to Micro Center's design require that it be printed with supports. I set the “Support Overhang” Angle to 46 degrees, and “Touching Buildplate”. The resulting print will create two tiny support structures, one for the cutout of the nut, and one in the center of the washer piece. Both tiny supports are very easily removed. This is just a quick remix of Micro Center's JST Connector Pliers. I probably should have looked here first before remixing it as I didn't realize there were already 5 remixes. I haven't looked at the others but I'm sure they're all great. My remix adds a 3rd piece, basically a washer the screw goes through. This remix requires a M4 x 10mm screw and M4 nut. My intent while I was remixing it was to use a button head M4 screw, yet when I went through my M4 hardware, the only screws I had that were 10mm long have socket cap heads. I suppose anything with a round head that is less than 8mm's wide will work. The nut is to be recessed into the opening provided.