JumpingJeep Bobblehead

My Brother likes his Jeeps, so I decided to make a jeep Boblehead. While I was at it, I though, why not make a bobblehead of him, bobbling on his jeep as it bobbles. And here it is. The Jeep is my own design, but I did take the body from the Joel bobblehead. I scaled it down a bit, but all seems to work fine (though I did have to sand the ends of the smaller spring to get them to fit in). In this model, I made the wheels loose, so you could take it off the base and roll it around, so I only glued the large spring to the base. The slot at the bottom of the jeep seemed to hold well without gluing. I broke the jeep into 2 parts, with the bottom half printing upside down. If you can print better than I can, you can go with the jeepfull stl file.