Just a little better.

Printed with PETG filament. 3 walls, 30% infill, 5 top layers, 5 bottom layers. Using K1 SE printer. Sides will print on a 220x220 build plate if rotated. Origional design was ok but side rails were not quite wide enough. Cans would tip slightly making for a bumpy ride. Slat tabs to connect sides were a little too tight to fit into slot and I saw no reason for the hole. I glued mine together with clear plastic pipe primer. BTW: If you print almost exclusively with PETG like I do, clear plastic primer made for pvc water pipe is a must have in your toolbox.