K1 SE Side Filament Mount (With K1 Logo)

A remix of a remix… of a remix! The only thing I've changed is adding a ‘K1’ logo to fuelvolts_1463543 remix, thank you very much to the original creators for this handy model. Credits go to: RobertoCorrea_773920 for the original model TowerTech3D for the changes/fixes to the original model fuelvolts_1463543 for adjusting the model dimensions to fit the K1 SE I printed using standard PLA which has been working great so far. My settings were: 0.4mm nozzle 25% infill - could likely get away with using 15% 0.2mm layer height - again, could likely get away with a bigger layer height Tree supports - original model didn't call for supports, but I used them just to be safe 2 wall loops