Katatmari Ball Xbox Controller Stand

This was my first attempt at any 3D modeling for 3D printing, so I'm 100% sure that this model could use improvements and would be delighted to see someone give it a go. I started with the Xbox controller model in Fusion. I created a basic shape, overlayed it on the model, and used the combine command to extract an approximate Xbox controller shape. Once I had that shape, I opened up the Katamari ball file, imported the Xbox controller shape, scaled up the Katamari ball, placed the Xbox controller shape in the ball, then used the combine command again. After that process, I exported the file out of Fusion as an OBJ and opened it up in Blender. In here, I did some smoothing of a few sharp edges and deleted a couple odd hanging mesh bodies that came out of the combine command. I printed this in PLA with supports on a Prusa MKS3+. It took around 26 hours to print and used a lot of supports, but printed without an issue.