Kobra 3v2 Ace Pro Top Mount

This design uses a 15 inch long plank (the size of the Ace Pro), along with two 2x2 studs cut to 18 3/4" This design is easy to make and very sturdy as it uses wood for all structural support, the printed parts hold everything together but they are not under stress. If you look at the photos you will see what i am talking about This build does requires you to screw in the lower back base parts with the bolts that are already there. (the bolts are longer on one side, take one bolt from each side and swap them or else only one side will fit snug and the other will be loose) I have only tested this model with the Kobra 3V2 ----------- (It should work with first gen Kobra 3, Comment below if you test it and it does) You can also extend the plank and place two Ace Pros on top ------------- (I have done it) DISCLAIMER: This build requires you to have wood cut to a custom size, I am not responsible for any injuries you might incur while cutting said wood. If you are not comfortable cutting wood go ask your daddy.