Lack Folding Door without rails using existing pocket door leg supports

I've had the pocket doors by @Drakka01 on my enclosure for a while now, but I wanted to change out to folding doors. I didn't want to reprint the enclosure parts, so I had to remix the hinges a bit to work with the existing pocket door parts. I created some connectors that are just super glued to the existing enclosure parts and then remixed the hinge to take into account the parts of the pocket door hinges that I didn't want to remove/reprint. The pocket door leg supports are still there (not the actual doors, of course, those are now the folding doors), just not used. The connectors are very specific to my setup, so will likely need a little modification to work on others. I also added a handle that goes on the upper right and lower right sections - no hinges on those - just a little extra handle. Refer to the original for instructions on how to put it together. You'll need the hingepins and the middle hinges from the original design. @MrSchwafel has a great design without the rails.