Led Strip Mounts for Star Wars Wall Diorama

I have created a few parts to better locate LED strips in Felte's Star Wars Wall Diorama/Picture Frame https://www.printables.com/model/816549-star-wars-wall-diorama-or-picture-frame These parts allow the LED strip to be attached (glue or if you are careful a 3D printer pen) and then mount the clear lens on it (glue) and then mount into the frame. I used single colour 5V (USB) LED strips of both White and Red for my build on the inner slots and didn't illuminate the outer (5 slot) holes on the frame. Not sure if the outer 5 slot reflector will fit at the same time as the 3 slot one. For me it consumes about 800mA from a USB plug pack. I used Silver PLA and it should print without supports.