Logitech G Pro Wireless (x-superlight-wireless) mouse case - Rugged Box (Parametric)

Update [23.7.2025] added versions for 25mm and 20mm long screws. *Added at the request of @SamC_3382651, I haven't printed them personally, but they should work without problems. Hello. I have a Logitech G Pro Wireless (x-superlight-wireless) mouse case here. This is a remix of “Rugged Box (Parametric)”. Easy to print. Durable but not waterproof. Perfect for traveling so that your precious mouse doesn't get damaged. Component: 6x M3 30mm screw . Two neodymium magnets - Height - 3mm Diameter - 6mm (they are not needed, but the mouse then attaches itself to the right place and stays there) Foam to keep the mouse in place - Made for foam from the original packaging which is then glued to the top cover. (if you no longer have the original box, you need foam about 5mm high) Installation : Magnets - If you want to use magenta, you need to insert them into the cover during printing at a height of 3.60 mm using the print pause in the g-code. Pay attention to the correct polarity of the magnet! Foam - You simply peel off the foam from the original box and stick it to the top cover in the marked circle using adhesives. Then screw everything together and you're done. The seal does not need to be printed! But it is in the original version, so I decided to add it here as well. If you decide to print the box, I would be delighted to see your photos :D.