Lucky 13 Mandalorian (With Jetpack and Rifle!)

I have modified and collected some Mandalorian parts for Lucky 13. All parts were printed at 0.15 or 0.20 unless otherwise stated. They were all printed on the Prusa MINI as well. Creators, if you see your stuff here and don't want it here, message me or comment on here and I will remove them as soon as possible. This model has used parts from these models in these ways: Lucky 13: https://www.printables.com/model/148367-lucky-13-printable-jointed-figure You will need this to build the figure. It is the basis of all Lucky 13 remixes. You may also want to print the display stand so you can pose your epic new hero in flight. Lucky 13 Mandalorian head: https://www.printables.com/model/243651-lucky-13-mandalorian-head/comments I include this file for ease of access. Maker81, if you want me to take it off please tell me. Lucky Stormtrooper: https://www.printables.com/model/199583-lucky-stormtrooper Modified chest piece to include a jetpack. Also included here are the shoulders, short neck, and chest without jetpack for ease of access. These will all be required for the full print. egz, please tell me if you want these removed. Star wars JT-12 Jetpack: https://www.thingiverse.com/thing:2083857/files Modified to match Mando's better and attached to the chest piece. It will need a bit of support material. You probably will want to set this to about 0.10 to make it a bit stronger on the little jets. You should be able to insert some filament into the jets to make flames. Din Djarin's Mandalorian Pulse Rifle: https://www.thingiverse.com/thing:4798635/files Attached a Lucky 13 compatible handle to it. I had to set this to 0.07 ULTRADETAIL to keep it from skipping layers (this will need supports).