Lucky 13 remix: R2-D2

UPDATE 2/10/2024: Be sure to check out the R2-D2 feet remix for use with the DUMMY 13 - Acrobatics pedestal I recently made a Lucky C-3PO by Printables user egz and decided there needed to be an R2-D2 to go along with it. If you like this, check out my Lucky 13 skin: General Grievous Assembly won't be difficult at all. If there is a [2X] next to the title of a piece, that means you need two of that piece. You will need supports for Head Skin - Grey.stl CHEST Pieces that you will need: Chest Skin - white.stl Chest Armature - white.stl Middle Foot - white.stl Chest part 1 - Blue.stl Chest part 2 - Blue.stl [X2] Chest Armature - white.stl fits into Chest Skin - white.stl and then connects to Middle Foot - white.stl while Chest part 1 - Blue.stl and Chest part 2 - Blue.stl [X2] fit into the Chest Skin as seen in the picture below. 📷 Image redacted — claim this model to add your own media HEAD Pieces you will need: Head Armature - Blue.stl Head Skin - Grey.stl Head part - black.stl Super easy assembly for the head. Head Skin - Grey.stl fits over top of Head Armature - Blue.stl and then Head part - black.stl fits into the head armature. 📷 Image redacted — claim this model to add your own media LEG Pieces you will need: Leg Skin - white.stl Outside Foot - white.stl Leg Armature - Blue.stl Again, super easy assembly. Leg Armature - Blue.stl fits into Leg Skin - white.stl and then snaps into Outside Foot - white.stl . Repeat the process for the other leg and the connect the Legs, Head and Chest. 📷 Image redacted — claim this model to add your own media