Luke Skywalker Lightsaber

This is a combination of UnimatrixRed's Luke's Lightsaber and Kaksu3D's Emitter remix. The middle of the lightsaber is hollow so that it is built over the top of a ½" diameter, 10" long metal rod. I used this one from Amazon. The additional weight makes it feel really good in your hand. I adjusted the black switch so that it fits into the holes of the control box easier. I had trouble printing the original black grip discs, so I split them in half for easier printing. I also thickened the black collar so that I could remove it from my print bed without cracking it. I removed the bumps on the ends of the D-Ring so that it fit into the holes of the pommel easier. No supports are required for any of my parts. See UnimatrixRed's instructions for assembly. Note that you'll need 17 of my black grip discs - one to add to the grip base and then 2 for each one of UnimatrixRed's black grip discs. I do not include here in my files the control box, the circuit board, the panel, the green/red LEDS, the switch casing, or the switch board. Those parts are available on UnimatrixRed's post.