M3x25 Adapters for Virus4711's Tablet and Notebook Stand

The original screws were too tight, so I made a sleeve and hex cover to fit M3x25 screws. You will have to screw the bolts into the sleeve adapters. It shouldn't be difficult to do. The sleeves are then used in the original joint holes that the original maker's bolts would fit into. The hex nuts are just to cover the hex slot the original designer made on the inside of each arm. I then placed a washer and nut on the end of the bolt. This also helps keep the arms from falling under the weight of heavier tablets. I printed these in .2mm and 100% infill. Here is the link to the screws I used: https://a.co/d/3vpwToB