Magnetic Plate

List of hardware needed: 4 M3x10-12 countersunk screws(or whatever you like) 4 M3 nuts 4 12x3mm Magnets(the stronger the better) Glue of your choice(Epoxy,CA, even got glue) Instructions: Its pretty self explanatory. Add a dab of glue on each magnet hole and press the magnets in. There is enough clearance to hold the magnet as the glue cures. As for the nuts, just insert them into the holes(gigidy) and just start screwing Printing instructions: Whatever works for you! My settings are: Layer hight: 0.2 Line width: 0.4 (PS Defaults) Ironing: ON (Flow rate : 26%, Spacing between iron passes: 0.2, Ironing speed 150mm/s) Results may vary!!