Magnetic switch remix for 6x3 magnets and better clearances

This is a remix of the Magnetic fidget switch by EG3Dprinting. In addition to using different magnets, I also tried to improve the clearance. I did see there was another remix of this model by bnorick, but it did not work too well for me, so I decided to make my own remix. This remix also includes a change to the lever to make it easier to install the magnets. The magnets in the case need to repel the magnets in the switch. Update: I have a new design available for the case that is only one piece and does not require glue. You must add layer pauses to input the embedded magnets in the case. You also must add a layer pause to drop in the switch. Remember to print the switch before the case , and remember to have the magnets in the case repel the magnets in the switch .